Geeetech

Posted: **Wed Feb 10, 2016 2:26 am**

Thank you Mark for reply, you got it right! "G2S extruder2 drives axial motors when printing". The solution linkhttp://www.geeetech.com/forum/viewtopic ... 13&t=17064 you suggested, did work for double hotend (two thermo sensors and two heating elements). It's complicated with Delta 3D printer and mixing hotend (one thermo sensor and one heating element with 2 or 3 extruders).

: G2S 2in 1 hotend mount; 2in1 G2S.JPG (202.84 KiB) Viewed 7797 times

E0 Printing single color

: G2S fan and 2in 1 hotend; 2in1 hotend.JPG (264.2 KiB) Viewed 7797 times

BTW, sometimes i can see in the system log something like "E1, communication error, system resetting"

Posted: **Wed Feb 10, 2016 8:13 pm**

glad it worked haha. but the communication thing you said, never seen it before...

Posted: **Fri Feb 12, 2016 6:16 am**

: 2in 1 mount 4 G2S 3D printer; IMG_3426.JPG (89.7 KiB) Viewed 7786 times

"E1, communication error, system resetting" It's gone after upgrading to new firmware.

: 2in 1 hotend mount; IMG_3425.JPG (98.31 KiB) Viewed 7786 times

Another thing, don't change axes "reverse true/false" in configuration.h, use defaults or Delta 3D printer will malfunction.

: G2S 2in 1 hotend mount; IMG_3424.JPG (100.11 KiB) Viewed 7786 times

Thank you Mark!

Geeetech

Using the 2-in-1out hotend with a G2s Pro

Re: Using the 2-in-1out hotend with a G2s Pro

Re: Using the 2-in-1out hotend with a G2s Pro

Re: Using the 2-in-1out hotend with a G2s Pro