Page 2 of 2
Re: Rostock 301 bugs report
Posted: Thu Dec 29, 2016 6:05 pm
by bang
Hi,Mikael
Yes,you need reflash it.The latest version is 1.0.0.2.
Read this:
http://www.geeetech.com/forum/viewtopic ... 20&t=18167
Re: Rostock 301 bugs report
Posted: Fri Dec 30, 2016 6:06 am
by Lami René
The latest version is 1.0.02 !
Re: Rostock 301 bugs report
Posted: Fri Dec 30, 2016 6:25 am
by MikaëlV
Hi,
I did read that
- but typically version numbers go Major.Minor.Patch. When I have a "1.1.0 A", then that is higher than "1.0.0.2"?
Can you indicate what are the different versions shipped? Or what are the differences from one version to the other?
Re: Rostock 301 bugs report
Posted: Fri Dec 30, 2016 7:02 am
by Lami René
Hello,
Bonjour,
You can find the original text into English following this original French text.
Vous trouverez le texte original traduit en anglais à la suite du présent texte original en français.
Pourquoi tout le monde répète la même erreur ?
Le numéro de la dernière version n'est pas 1.0.0.2, le bon numéro de version est 1.0.02 !
Cordialement,
L'ami René
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Hello,
Excuse me, I am unilingual francophone and I use Google translator to translate the texts of the forum in French and to write to you in English. Thank you for your understanding and your indulgence for these texts translated mechanically!
Why does everyone repeat the same mistake?
The number of the latest version is not 1.0.0.2, the correct version number is 1.0.02!
Cordially,
Friend René
Re: Rostock 301 bugs report
Posted: Wed Jan 18, 2017 4:26 am
by MikaëlV
flintewn wrote:Same first 2 bugs as raoulito9.
...
M104 S0 ; turn off temperature
G28 ; home axis
M84 S0 ; hold motors
...
M84 S0 doesn't hold the motors for me - at least not from manual control in Repetier host - the command that does hold the motors in manual control is
M17
...
Lami Rene wrote:
...
M300 S1244 P500
...
No beep here with latest FW...
Re: Rostock 301 bugs report
Posted: Thu Jun 15, 2017 4:05 am
by vesuvius
Did you solve your problem?
My end script is G28, to remove hotend from my nice print !
G 28 works, but just after, steppers switch off and the the still very hot hotend crashes into my print.
I tried the M17 command, but nothing changes.
After a successful print.