Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/

Problem on prusa i3 pro b

http://forum.geeetech.com/viewtopic.php?t=18407

Page 2 of 2

Re: Problem on prusa i3 pro b

Posted: Sat Nov 05, 2016 10:09 pm
by jauffrey
Finally I found the problem, I'm very stupid, it was just the nut hurting the plastic before it the plate activate the Y min endstop (the following picture)

THANKS A LOT WILLIAM

Best regards Jauffrey

Re: Problem on prusa i3 pro b

Posted: Mon Nov 07, 2016 2:26 pm
by William
Congratulations,Jauffrey.So glad to see that. :D
All times are UTC+08:00
Page 2 of 2

Powered by phpBB® Forum Software © phpBB Limited