Page 2 of 2
Re: GT2560 Rev. A+ schematic
Posted: Wed Jun 20, 2018 12:39 pm
by _kaktus_
HI
[attachment=1]Hardware_GT2560_RevA+_1.png[/attachment]
[attachment=0]Hardware_GT2560_RevA+_2.png[/attachment]
Re: GT2560 Rev. A+ schematic
Posted: Fri Jul 20, 2018 7:54 pm
by A_Camera
[quote=5a2v0 post_id=84664 time=1529413397 user_id=66394]
hi, I have a geeetech prusa i3 pro b.
on the pwm fan pin i got 5v when repetier host was set at 100% fan.
is it normal or i must have 12v?
[/quote]
No, it is not normal. 100% should be 12V not 5V. If you get 5V you measure it wrong or something is wrong with your card. PWM output should give you 6V if fan speed is set to 50%, 5V is about 42%.
Re: GT2560 Rev. A+ schematic
Posted: Fri Jul 20, 2018 7:55 pm
by A_Camera
Ginko, you are wrong.
Re: GT2560 Rev. A+ schematic
Posted: Mon Jul 23, 2018 7:17 pm
by Gingko
Sorry I made the mistake!
I check it, it's around 12V when the rate is 100%.
Thanks for pointing out.