Page 2 of 2
Re: Layershiftig on y axis
Posted: Sun Jan 06, 2019 1:18 pm
by buttervonwaffle
Yeah I know I didn't know that when I Initially Installed it. Needless to say I was ecstatic to find that out. Jerk was way to picky it really lightens the load when it comes to tuning it in. Thanks for bringing that to the threads and putting that work in, it is greatly appreciated!
Re: Layershiftig on y axis
Posted: Tue Jan 08, 2019 9:34 am
by hofschalk
Stupid question: how do I install 2.0. I updated to 1.9 with a hex file via octoprint.
Re: Layershiftig on y axis
Posted: Thu Jan 10, 2019 1:45 pm
by Gandire48
I asked about layer shifting on the Facebook page . Repy was to lower the ACCel speed to 1000. I also lowered the Amax X to 2000, and the Amax Y 200 and lowered JERK to 10. Seems to help some parts I still run at 70-80 % speed
Re: Layershiftig on y axis
Posted: Wed Jan 30, 2019 12:17 am
by bernte_one
Hello Vert,
thanks for your work.
Will try your new Firmware too.
Last FW was from user rundundfun 1.9.1...?
it has 9 point levelling, has your firmware similar function included, i found this very usefull