Re: Geetech a10m x-axis belt motor slide
Posted: Tue Apr 14, 2020 1:33 am
I have turn belt , no change
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://forum.geeetech.com/
Geetech a10m x-axis belt motor slide
Page 2 of 2
Re: Geetech a10m x-axis belt motor slide
Posted: Tue Apr 14, 2020 3:22 am
???
Re: Geetech a10m x-axis belt motor slide
Posted: Tue Apr 14, 2020 10:20 am
Hi，
it may be that the belt is too tight, you can adjust it properly.
it may be that the belt is too tight, you can adjust it properly.
Re: Geetech a10m x-axis belt motor slide
Posted: Tue Apr 14, 2020 9:18 pm
I repeat once again:
whatever the setting of the belt: stretched, relaxed, half stretched.
it goes on the engine side, always always always
whatever the setting of the belt: stretched, relaxed, half stretched.
it goes on the engine side, always always always
Re: Geetech a10m x-axis belt motor slide
Posted: Wed Apr 15, 2020 1:50 am
Re: Geetech a10m x-axis belt motor slide
Posted: Wed Apr 15, 2020 11:53 am
Hi，you can adjust the position of the buckle.
Re: Geetech a10m x-axis belt motor slide
Posted: Wed Apr 15, 2020 3:22 pm
hello, I think you take me for a moron, I have a cr10 and an anet, so I can adjust a strap I can adjust loops too.
the strap twists it and not flat ok. I bought the printer with this defect. so I repeat a few whatever the location it stays in the same place. I'm going to twitter and make a video on the youtube channel at least if that means avoiding people buying your poor quality material ....
Re: Geetech a10m x-axis belt motor slide
Posted: Wed Apr 15, 2020 3:52 pm
I am so sorry, you can contact the salesman to replace the belt.