Geeetech

Could be the same problem that in this thread? http://www.geeetech.com/forum/viewtopic ... 19&t=18010

I can confirm that it's an extruder design problem:



I put an element to block the pressure system and then it worked again. What can we do? Extruder replacement?

Regards

stark0 wrote:I can confirm that it's an extruder design problem:



I put an element to block the pressure system and then it worked again. What can we do? Extruder replacement?

Regards

Hi,
It is weird,i can't see your pic...Since that,i guess it's the bad spring caused this.To solve the problem,you can contact the seller resend you serveral springs,and it may work.
Regards

Hi,

after replacing the feeder system for the old one I can confirm that the feeder was the problem. Now I'm able to print 10+ hours without problem in PLA and I'm happy with the printer.

Regards!

stark0 wrote:Hi,

after replacing the feeder system for the old one I can confirm that the feeder was the problem. Now I'm able to print 10+ hours without problem in PLA and I'm happy with the printer.

Regards!

Hi!

Are you talking about aluminum version?

Best regards.

Hi,

yes, I replaced this one: http://www.geeetech.com/mk8-extruder-fe ... 8tfefcp3u5

for this one:
http://www.geeetech.com/mk8-extruder-al ... p-995.html

Regards

I got the same problem with my MK8 2. Had to adjust the spring tension with washers. By design my tension can't be higher by now. It will hit the stop.

stark0 wrote:Hi,

yes, I replaced this one: http://www.geeetech.com/mk8-extruder-fe ... 8tfefcp3u5

for this one:
http://www.geeetech.com/mk8-extruder-al ... p-995.html

Regards

I'm looking at this solution. Do we buy the short or the long one? I can't find an explanation of the differences. Thanks!