Page 7 of 39
Re: Firmware for geeetech 3D printers
Posted: Sat Aug 06, 2016 7:46 am
by derrenball
hi i have a I3 pro B and want to put auto leveling on the system. i have my sensor but can not seem to find the auto level on the lcd menu do i need to change the firmware and if so to what version.
thanks
Re: Firmware for geeetech 3D printers
Posted: Sat Aug 06, 2016 8:53 am
by Toy
derrenball wrote:hi i have a I3 pro B and want to put auto leveling on the system. i have my sensor but can not seem to find the auto level on the lcd menu do i need to change the firmware and if so to what version.
thanks
You need to modify the firmware yourself, here's a link I think may be helpful to you:
http://shop.prusa3d.com/forum/software- ... -t416.html
Re: Firmware for geeetech 3D printers
Posted: Fri Aug 12, 2016 2:57 am
by Bernd
which Firmware can i use for the Geeetech mendel i3 ???
Thanks
Re: Firmware for geeetech 3D printers
Posted: Fri Aug 12, 2016 8:46 am
by William
Hi,
Which printer model do you have?You can download the corresonding firmware from the following link:
http://www.geeetech.com/forum/viewtopic ... 20&t=17046
Re: Firmware for geeetech 3D printers
Posted: Fri Aug 12, 2016 2:26 pm
by Bernd
- 13901422_10206806536977429_3995656740785004392_n.jpg (32.67 KiB) Viewed 44527 times
this one on the Picture have a friend and he dont´t now which one this are !
Re: Firmware for geeetech 3D printers
Posted: Fri Aug 12, 2016 2:56 pm
by William
The one on the picture is I3 ProB,you can tell him to download the firmware for I3 Pro B.
Re: Firmware for geeetech 3D printers
Posted: Sun Aug 14, 2016 12:25 am
by abecher
I have a prusa I3 pro C what firmware should I be using thanks for the help
Adam
Re: Firmware for geeetech 3D printers
Posted: Sun Aug 14, 2016 1:52 am
by Bernd
- fehler.JPG (60.4 KiB) Viewed 44511 times
ok he has this one with ramps 1.4 and we try to upload the firmware PI3B-Ramps.zip ! And we habe thios problem .. look at this pic..
Re: Firmware for geeetech 3D printers
Posted: Mon Aug 15, 2016 9:17 am
by William
abecher wrote:I have a prusa I3 pro C what firmware should I be using thanks for the help
Adam
- QQ截图20160815091504.jpg (11.46 KiB) Viewed 44506 times
Re: Firmware for geeetech 3D printers
Posted: Mon Aug 15, 2016 9:20 am
by William
Bernd wrote:fehler.JPG
ok he has this one with ramps 1.4 and we try to upload the firmware PI3B-Ramps.zip ! And we habe thios problem .. look at this pic..
Hi,
Try the arduino version 1.0.1 to see if it makes a difference,download it from here:
http://www.geeetech.com/wiki/index.php/ ... _Resources