Geeetech

I have this board that came with this printer; http://www.dx.com/p/geeetech-rostock-mi ... lue-349046



Everything is hooked up as indicated with corresponding end-stops for each motor. But when operating the printer (hooks up just fine to Repetier running marlin firmware), z-xis motor is reversed so that it always moves down from 0+, either through repetier or directly in the lcd control panel; making calibration with end-stops and printing impossible. How do I fix this?

Also, what are these for :



Thanks for your time!

Hi IgorAntunov
You can reverse the direction of the 4-pins plug about z-axis, and reconnect it the to the main board.
Or you can edit the firmware: change the INVERT_Z_DIR--TRUE to FALSE, or the opposite. And they're heatsinks, you can install them on the motor driver. Sincerely
Harry

Ah thanks, will try!

Edit: what is the safest way to edit the firmware? Do I have to burn a new version?

Edit2:

Please tell me precisely which version of Marlin firmware goes with this sanguinololu 1.3a/atmega1284 board/chip combo. I just installed the wrong one. The SD card that came with the printer was fried/broken, I assume that had some software on there. Is it marlin version 1.0?

Hi IgorAntunov
Here are all the software resouces in our official website.They are verified and can help you.
http://www.geeetech.com/wiki/index.php/ ... _Resources