Page 1 of 2
Problem to connect to Repetier
Posted: Tue Mar 31, 2015 2:45 am
by hiram.uribe
Hi, i have some problems.
1. When i connect the ME Creator to Repertier i found the port and made the connection, but i cant see the temperatures and i can not move anything.
2. Where I connect de Screen? I need to change de firmware?
3. Can you mail me the firmware to
hiram.uribe@hotmail.com?
4. Can I use Marlin firmware?
Re: Problem to connect to Repetier
Posted: Tue Mar 31, 2015 10:21 am
by john
You don't need to re-upload a firmware, we had uploaded a Marlin firmware for your machine.
Can you home all axis when clicking on HOME button?
Visit the wiki page for your motherboard and it will show you how to connect a LCD screen.
Re: Problem to connect to Repetier
Posted: Thu Apr 09, 2015 12:38 am
by hiram.uribe
No, when i select home all the printer dont move.
Re: Problem to connect to Repetier
Posted: Thu Apr 09, 2015 10:19 am
by zhangxueyou
Can you control the motors on LCD screen?
Re: Problem to connect to Repetier
Posted: Fri Apr 10, 2015 12:20 am
by hiram.uribe
How connect the LCD?
I connect tthe LCD in the Card but i dont see anything, is there some manual about how to connect de LCD? I need change the firmware?
Re: Problem to connect to Repetier
Posted: Fri Apr 10, 2015 9:28 am
by zhangxueyou
No, as you turn the printer on, the LCD is on too.
So please tell me, how is the LCD? Is it dark, or just glowing without displaying anything?
Re: Problem to connect to Repetier
Posted: Sat Apr 11, 2015 1:01 am
by hiram.uribe
Is glowing without displaying anything
Re: Problem to connect to Repetier
Posted: Sat Apr 11, 2015 9:38 am
by zhangxueyou
Please rotate the little screw above SD card on the back side of LCD, check if there is any change.
Re: Problem to connect to Repetier
Posted: Wed Apr 15, 2015 11:09 pm
by hiram.uribe
LCD is glowing just few seconds, then turn off . What can i do?
Re: Problem to connect to Repetier
Posted: Thu Apr 16, 2015 8:48 am
by zhangxueyou
When you connect your printer to computer, you should turn on the printer. Computer provides only 5V voltage.