Page 1 of 1

Software Setup before print

Posted: Thu Apr 02, 2015 4:21 am
by Mmmsabeel
Hi

i have installed the repetier software and can anyone give me proper setting i have to follow for below printer configuration ?

Acrylic Geeetech I3 pro B 3D Printer
Repetier-Host, windows 7
nozzle 0.3mm
Filament 1.75
ABS filament.

Best Regards
sabeel

Re: Software Setup before print

Posted: Thu Apr 02, 2015 8:26 am
by zhangxueyou
You can refer to the attachment. Though mine is not the best.
slicer settings(1.75-0.3).rar
(719.11 KiB) Downloaded 657 times

Re: Software Setup before print

Posted: Sat Apr 04, 2015 3:21 am
by Mmmsabeel
hi,

after applying the settings that you gave me it does not print well. it prints rectangle instead of square and prints out of the bed and it does not fill properly

i have attached the picture pls check and it printed well with default settings much better than this. what myt be causing this ?

Re: Software Setup before print

Posted: Sat Apr 04, 2015 2:14 pm
by zhangxueyou
Is the model you are printing too big to print? If not, do you have firmware? I can tell you how to modify relevant parameters.