Z and X axis end stops
Posted: Sat Apr 04, 2015 4:18 pm
Have a strange troubles with my Z and X axis end stop, the only one that works properly is the y axis . have tried to change cables tested a completely new ramps cards with the exact same firmware without great results. the firmware have I received of geeetech so yeah assumes that it will be ok.
also even compared it against standard marlin.
The problem in itself results in that I can not calibrate the axis against the heat bed because I do not get a zero value on the axis .
I receive a zero value on the y axis
so it works of course as it should
also even compared it against standard marlin.
The problem in itself results in that I can not calibrate the axis against the heat bed because I do not get a zero value on the axis .
I receive a zero value on the y axis
so it works of course as it should