Geeetech

Posted: **Thu Aug 13, 2015 1:41 pm**

Hi,

I have purchased and assembled a Geeetech Prusa I3X. During first test and calibrations one question arised:

- how do I set the center position (X, Y) in my printer so that the printing job is centered in building plate?

This is what happens now (X representing center point):

Code: Select all

 -------------
 |           |
 |           |
 |           |
 |     X     |
 |           |
 -------------        
    FRONT

This is how it should be? (X representing center point):

Code: Select all

 -------------
 |           |
 |           |
 |     X     |
 |           |
 |           |
 -------------        
    FRONT

Posted: **Thu Aug 13, 2015 6:33 pm**

you mean like this ?

Posted: **Thu Aug 13, 2015 6:40 pm**

Than you Mark so much - this the case! Solution seems to be very simple - even for a newbie like me

Posted: **Sun Jan 10, 2016 10:04 pm**

Mark, where is that screen? In printer settings or Slic3r config? I have looked around and cannot find it. My pro C prints to the right enough that the extruder smacks the Z axis if I dont move the object over to the left.

Posted: **Tue Jan 12, 2016 4:56 pm**

this is in the slic3r settings in repetier host 1.6.0. And how about adjust the settings here:

: QQ截图20160112165507.jpg (142.74 KiB) Viewed 9143 times

Posted: **Tue Jan 12, 2016 9:04 pm**

Thanks!

Geeetech

Prusa I3 X - Building plate centering

Prusa I3 X - Building plate centering

Re: Prusa I3 X - Building plate centering

Re: Prusa I3 X - Building plate centering

Re: Prusa I3 X - Building plate centering

Re: Prusa I3 X - Building plate centering

Re: Prusa I3 X - Building plate centering