Geeetech

Hi everybody!
Sorry my english is not so good.
I have a Prusa I3 Pro B printer with 2560 rev a controller board.

i have a 3 problem.
1: The printer not connec with Repetier host. I think peoblem with the baud rate. How much the origonal baud rate?

2: I print with SD-card. Make one-pair layer after Stop the machine (in process) and stop printing. why? What do you think how to solve? Maybe firmware refresh?

3: In print process if not stop the machine ( Like 2poit ) go out the filament after continue the printing without filament... The motor is work only the filament stuck in the feeder. Picture: Thank you for your help!
Have a nice day!

1. the baud rate for this printer is 250000, you can check the user manual to set up the printer.
2. Regard to question 2and 3, I think maybe the slic3r settings of your printer are not proper, you can use my settings here:

Scope of 3D printing increase and now there is a large quality of printers with amazing features are available to meet requirements of users. Using australia writings service is one of my best experiences so far and I must say you should try for better quality content.

I am facing the same problem and I am so busy in providing dissertation help (official source). As soon as I will be free from providing the help I will care take of it and if it does not work I will google it then I will call someone who has specialized in making printers.