Geeetech

Hi i just purchased a prusa i3 pro B and i'm experiencing a problem,

Everything went well building it, and everything is working fine when i'm using the users commands, but when i'm printing after a short moment the y axis motor only move in one way and instead
of moving in the other way it is vibrating, i already tried to resolve it by changing the voltage but it seems that it isn't the issue.

Does anyone have experienced the same problem ?
I would love some help here =)

If every works well when you using manual control, please check your slicing

Hi, first of all thank you for your fast aswer,

I tried 2 diffrent slicer and it dosn't change anything, but i figured that when i'm playing a little while longer with the motor
using the users comand it does the exact same thing, could the A4988 defective ?

http://www.geeetech.com/forum/viewtopic ... 17&t=17038
you can refer to this post for troubleshooting

have you find any solution yet?
I have the same problem
I Will check links provided in the morning.