Page 1 of 1
Printer would not connect after updating to 1.0.5 firmware
Posted: Tue Jun 14, 2016 9:31 pm
by Edvash
Printer would not connect after updating to 1.0.5 firmware
the firmware was successfully updated, it works as a standalone, however , i can't connect it to the PC anymore
any suggestions?
Edan
Re: Printer would not connect after updating to 1.0.5 firmwa
Posted: Wed Jun 15, 2016 3:47 pm
by William
Edvash wrote:Printer would not connect after updating to 1.0.5 firmware
the firmware was successfully updated, it works as a standalone, however , i can't connect it to the PC anymore
any suggestions?
Edan
Hi，Edvash
Has your devices manager detected this？If it has,you must choose the corresponding "COM" port in your slicer software.
- 1.png (76.25 KiB) Viewed 4140 times
If hasn't,you can try to change a USB port or a USB wire,that may work.
If all above have done and it doesn't work,i'm afraid you'd better return to the firmware you used before.