Some ideas?M201 - Heating extruder
M201 - Heating extruder
The heating of the extruder will never end. Repetier-Host Mac 0.56 display Extruder 2: -19°C. I'm not cold. Some ideas?
Some ideas?- Attachments
-
- Screenshot at Juni 18 19-24-58.png (14.92 KiB) Viewed 5067 times
Re: M201 - Heating extruder
Something wrong with your extruder2 thermistor?gift wrote:The heating of the extruder will never end. Repetier-Host Mac 0.56 display Extruder 2: -19°C. I'm not cold.
-Keep your mind and try to test it.
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: M201 - Heating extruder
Aloha William,
the pdf doc describes "Connect heating wires for hotend to hotend 1. " The wiki: "Connect heating wires for hotend 0." That's good.
the pdf doc describes "Connect heating wires for hotend to hotend 1. " The wiki: "Connect heating wires for hotend 0." That's good.