Page 1 of 1
Will not auto home and Z rods bent
Posted: Wed Sep 07, 2016 10:38 pm
by jsguster
Hello everyone! I have a Acrylic I3 Pro B and I can not get it to auto home. All axis move about an inch then stop never hitting the stop switches. Also my threaded rods for my Z axis are bent causing my extruder to rock back and forth a little. I hope someone can help me with this. Thanks
Re: Will not auto home and Z rods bent
Posted: Thu Sep 08, 2016 10:17 am
by William
jsguster wrote:Hello everyone! I have a Acrylic I3 Pro B and I can not get it to auto home. All axis move about an inch then stop never hitting the stop switches. Also my threaded rods for my Z axis are bent causing my extruder to rock back and forth a little. I hope someone can help me with this. Thanks
Hi,
1.Make sure all your endstops are plugged in the corresponding socket X_min,Y_min,Z_min.
2.About the bent Z axis,you can contact the seller for the replacement.