Rostock 301 z Calibration
Posted: Sun Sep 18, 2016 12:06 am
Hi.
I'm used to delta calibration because i had a G2S, i now have a 301.
My problem is tha i can't find where to modify the fact that the printer compensates a "concav shape" of the bed.
For G2S, in MArlin, it was easy in config H, but i can't find this in 301 Firmware.
The effect is that if the head is on Z=0 close to each of the 3 towers (y, or y or Z), perfect distance from bed, at the center of the bed (X=,Y=0, Z=0), the head is at 1 mm from it.
As if my bed was concav.
Where can i ajust this ?
Thank you for help/.
I'm used to delta calibration because i had a G2S, i now have a 301.
My problem is tha i can't find where to modify the fact that the printer compensates a "concav shape" of the bed.
For G2S, in MArlin, it was easy in config H, but i can't find this in 301 Firmware.
The effect is that if the head is on Z=0 close to each of the 3 towers (y, or y or Z), perfect distance from bed, at the center of the bed (X=,Y=0, Z=0), the head is at 1 mm from it.
As if my bed was concav.
Where can i ajust this ?
Thank you for help/.