Problem with yun shield rebooting
Posted: Fri Sep 30, 2016 12:30 am
I connected my yun shield to my arduino mega for the first time yesterday and connected to the wifi using my pc. I then logged into the yun to change the network settings so it would connect to my home network.
When i change the SSID and Password settings and hit update, the yun saves the new settings but gets stuck when trying to reboot and the progress bar freezes at the end. I have tried a factory reset of the shield before attempting to change the settings again but I'm not having much luck.
I also tried updating the firmware. The new firmware uploaded correctly but the yun freezes again while it's trying to reboot and the progress bar stops at the same point. I assume if i disconnect the shield while trying to update the firmware, damage will occur?
Has anyone any idea how to sort this problem?
When i change the SSID and Password settings and hit update, the yun saves the new settings but gets stuck when trying to reboot and the progress bar freezes at the end. I have tried a factory reset of the shield before attempting to change the settings again but I'm not having much luck.
I also tried updating the firmware. The new firmware uploaded correctly but the yun freezes again while it's trying to reboot and the progress bar stops at the same point. I assume if i disconnect the shield while trying to update the firmware, damage will occur?
Has anyone any idea how to sort this problem?