Problem with 8mm and bearing x and y axis
Posted: Wed Apr 05, 2017 3:33 am
Good mooring,
i have just finish my Acrilic prusa I3.
During the mount I check just a problem, two 8mm shaft don't work well in the bearing.
At the end of assembled the printer don't work well; the motors don't have the power to move the axis, also with had it not real free.
i have just finish my Acrilic prusa I3.
During the mount I check just a problem, two 8mm shaft don't work well in the bearing.
At the end of assembled the printer don't work well; the motors don't have the power to move the axis, also with had it not real free.