Assembly Procedures and instructions
Posted: Thu Apr 06, 2017 3:35 pm
Ordered and received Geeetech Prusa i3 M20126 September last year. Had to leave it in storage until recently ready to assemble.
Followed Downloaded .pdf and videos until step 24. Whoa!! No extension boards (Part 68) nor (69) or (M6). Something different?
The extruder motors seem differently assembled, and had to drill M6 holes in mounting brackets to fit the motors
Control Board, No (74) is Totally Different!!! Which Cables go where?????
Followed Downloaded .pdf and videos until step 24. Whoa!! No extension boards (Part 68) nor (69) or (M6). Something different?
The extruder motors seem differently assembled, and had to drill M6 holes in mounting brackets to fit the motors
Control Board, No (74) is Totally Different!!! Which Cables go where?????
