extruder eating right away G2S pro
Posted: Wed May 10, 2017 7:31 am
I just finished building my Delta Rostock mini G2S pro.
When I power up my printer, the hot end (the nose)#2 is starting eating right away, without asking, event if it's not plugged into the computer.
I cannot continue calibrating my printer until it's fixed, because, after 2 minutes, It's starting to smell weird.
Please help me
When I power up my printer, the hot end (the nose)#2 is starting eating right away, without asking, event if it's not plugged into the computer.
I cannot continue calibrating my printer until it's fixed, because, after 2 minutes, It's starting to smell weird.
Please help me