Geeetech

Hi

I would like to know if this printer is able to use the NinjaFlex filament:
https://ninjatek.com/products/filaments/ninjaflex/

Have you used it?
What parameters did you use?

Regards - Pedro

Hi,maybe you can have a first try .I find some related printing guidelines in the link you send:
"Extruder Temperature: 225°C – 235°C
Platform Temperature: Room temperature – 40°C
Glue and/ or blue painters tape is suggested if not using a heated bed.

Print Speed:
Top and bottom layers: 10-20 mm/ sec (600-1200 mm/ min)
Infill speeds: 15-35 mm/ sec (900-2100 mm/ min)
Layer 2+ use cooling fan if available."

Check out this YouTube video, very interesting!

https://www.youtube.com/watch?v=KBbsDQWfrwA

Play Bonny!

Soadyheid