Geeetech

Hi.

My prusa I3pro In Extruder not pulse.
I use a measuring oscilloscope. There are no signs in the extruder. Using an oscilloscope to measure the x, y, z are billed as a regular signal.
Who knows, please help me. I have taken the clip may not be sharp, sorry. Can someone explain or help me?

Link:--> https://youtu.be/VGOtXLhxz04
]Sorry for the language I'm not good at.

Thank.

Hi.

I want E0 to use pin for E1 and pin for E1 use pin for E0. I suspect E0 pin command has a problem inside ATMEGA2560.
How do I edit the code?

Thank.

It should be mentioned that the extruder only works when it heats up to over 170 degrees.

If you want to use E1 slot, refer to this post:
viewtopic.php?f=20&t=18020

Gingko wrote: Fri Jul 27, 2018 5:20 pm It should be mentioned that the extruder only works when it heats up to over 170 degrees.

If you want to use E1 slot, refer to this post:
viewtopic.php?f=20&t=18020

Hi Gingko

I use a multimeter on my GT2560 board, it does not match any pin at all. Show on the attached picture red text is the pin that I measured.

Thank.