Page 1 of 1
Connector type for J3 connector in main board?
Posted: Wed Sep 19, 2018 7:29 am
by apak
Could somebody tell me the name for the J3 "wifi" connector on GTM32 mini board (1x8 pin connector)
It´s not a regular pin connector, it´s smaller.
thanks
Re: Connector type for J3 connector in main board
Posted: Wed Sep 19, 2018 3:59 pm
by apak
This connector is smaller, and I am doing some test with ESP3D and work like to pin some cables there, and would not like to solder wires...
Could it be a JST-SH 1.0mm 8-Pin?
Re: Connector type for J3 connector in main board?
Posted: Thu Sep 20, 2018 1:47 am
by _kaktus_
Hi
Yes, it's a regular goldpin connector.
All you need to know about it is raster. In this case it is
1.27mm.
Re: Connector type for J3 connector in main board?
Posted: Sun Dec 30, 2018 2:01 am
by curso
Hi,
Any luck with this J3 connector and ESP3D?
If yes can tell me what are the pins to use?
Thanks
Re: Connector type for J3 connector in main board?
Posted: Fri Jan 11, 2019 4:17 am
by _kaktus_
Hi.
You will find the answer by browsing the diagram of this electronic circuit.
It is available on
GitHub GT.
Re: Connector type for J3 connector in main board?
Posted: Fri Jan 11, 2019 5:40 pm
by apak
proyect is stopped until working and stable source code is release on github....
manage to do it on and A20M, but it uses marlin and code is available, not so with smartto code...