Page 1 of 1
A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Tue Oct 16, 2018 8:32 pm
by millenium7
I received my A10M, assembled it and when I plug it in and turn it on, the fans spin, a couple red LED's come on on the unit itself, but the screen is lit up with all symbols filled in and doesn't appear to be responsive. I don't know if it has a beeper but pressing the button or turning the wheel does nothing
I've tried turning it off and on a few times, always the same. I tried reconnecting the LCD cable a few times, it's firmly in and connected. I had a quick look at the board I can't see anything obvious. I connected the 3D Touch and that cycles a couple times on first startup, dunno if that says anything
Anyone know whats going on?
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Tue Oct 16, 2018 10:05 pm
by _kaktus_
Hello.
You should load the firmware.
But please don't ask what where and how, just start reading the forum.
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Wed Oct 17, 2018 6:18 am
by millenium7
So it doesn't come with firmware out of the box?
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Wed Oct 17, 2018 7:33 am
by millenium7
I'm trying to update the firmware but i'm just getting this
Yes i'm using the correct COM port. Tried restarting the printer same thing
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Wed Nov 28, 2018 10:44 pm
by carre82
first assembly
mine if not lighting at all
only d5 led on mainboard lights steady state
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Fri Nov 30, 2018 11:23 am
by William
Ask the sales to send you the new motherboard.
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Fri Nov 30, 2018 10:56 pm
by _kaktus_
Hello.
vert wrote: Wed Nov 28, 2018 11:03 pm
I get the same thing bootloader corrupted on me.
I agree with this opinion.
After the firmware has been loaded correctly, everything should work as it should.
I mean: application program + bootloader.
Re: A10M - freshly assembled, turns on, all LCD symbols solid
Posted: Sat Dec 01, 2018 9:27 am
by 3dGenie
Looks like a fried bootloader to me. Had the same issue on my Anet A8. Try this
https://www.instructables.com/id/HOW-TO ... DUINO-UNO/