Page 1 of 1
Problem or normality?
Posted: Tue Jan 29, 2019 4:10 pm
by GDWork
Yesterday I got my geeetech A20M. I have not power the unit, because when I move the print bed, it turns on the display, led power supply and more. Is this normal?
https://drive.google.com/file/d/1erbvaM ... p=drivesdk
Re: Problem or normality?
Posted: Tue Jan 29, 2019 11:57 pm
by _kaktus_
Hello.
This phenomenon is undesirable.
When you set the motor in motion, it starts to work like a generator.
Try not to do so. This can be dangerous for the electronics of the printer.
Besides, everything is fine.
Re: Problem or normality?
Posted: Wed Jan 30, 2019 5:03 am
by GDWork
Power on or nothing? I'm scared.
I'll try it.
Re: Problem or normality?
Posted: Wed Jan 30, 2019 4:29 pm
by _kaktus_
Hi.
You don't have to be afraid, it's enough that you don't have to move the mechanisms manually.
Or, if necessary, do it very slowly.
Re: Problem or normality?
Posted: Wed Jan 30, 2019 5:37 pm
by GDWork
Ok. Thank you very much
Re: Problem or normality?
Posted: Thu Jan 31, 2019 9:30 pm
by GDWork
Printer power ok. I try to print a dog file in sd card but the extruder temperature will stop at 92°C instead 190°C and heatbed will stop at 45°C instead 60 °C. The printer isn't connect to pc for this first tests. It comes with marlin 1.1.18. PID setting wrong or anything else?
Re: Problem or normality?
Posted: Tue Feb 05, 2019 8:20 pm
by GDWork
Now it's work pertectly. Thank you
Re: Problem or normality?
Posted: Tue Feb 05, 2019 11:32 pm
by _kaktus_
Hi.
You can write how you managed to solve the problem. This will be helpful for other users.
Re: Problem or normality?
Posted: Wed Feb 06, 2019 6:42 am
by GDWork
I just reinstalled marlin firmware 1.1.8. Everything was blocked when I attached printer to pc and run arduino software for save and modify firmware setting in the machine.
Now I'm waiting for the 3D touch sensor and will reinstall it again.
Re: Problem or normality?
Posted: Fri Feb 08, 2019 11:09 am
by TMeeks
You will love the 3D Touch. We had to flip the mount on the left side of the print head. But, it is relatively easy to install. PM me is you run into anything unusual.