Is my GT2560 V3 defect ?

Post Reply
Moscher
Posts: 4
Joined: Thu Dec 13, 2018 2:59 pm

Is my GT2560 V3 defect ?

Post by Moscher »

my new A10 printer seems to be broken. :(

The Z axis dont move anymore.

I switches the stepperdrivers and changes motor cables to make sure it is the board itselfe.
On other axis the Z motors and steppers work fine!

the 5 Volt led is dark and does not shine.

is there a way to check the board something else?

Anyone have a tip for me please!?
Top
User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:
Contact _kaktus_

Re: Is my GT2560 V3 defect ?

Post by _kaktus_ »

Hello.
:mrgreen:

Can you show a photo with the LED you are talking about :?:
I expect that if the 5V lamp didn't light up, nothing would work.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Top
Moscher
Posts: 4
Joined: Thu Dec 13, 2018 2:59 pm

Re: Is my GT2560 V3 defect ?

Post by Moscher »

Oupsy, your right! I looked wrong, the 5 volt led work.

I hope a new board comes today than i can do a new try.
Top
Post Reply

Return to “Control Board”