Page 1 of 2
+ 10 mm Z axis at beginning printing
Posted: Wed Jun 05, 2019 10:09 pm
by ddanos
Hello everyone, I have a PI3 PRO C, SW 1.0.04.
The problem is the z axis: when print begins, it starts at 10 mm above the bed.
I use Repetier.
Any idea?
Thanks.
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 06, 2019 9:14 am
by William
Hi, Have you leveled the hot bed before printing?
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 06, 2019 1:09 pm
by ddanos
Yes, the bed is leveled and the home point is perfect.
Here you have a video
https://youtu.be/F53eqbg-bfQ
Thanks.
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 06, 2019 1:41 pm
by William
Hi, You can adjust the z-axis height by manual adjustment or by the slicing software. Manual adjustment requires moving the nozzle to the middle of the print bed and zeroing the Z-axis. Make sure that the nozzle does not touch the hot bed or is too far away from the hot bed. A preferred condition is that when the consumable is extruded from the inside of the nozzle to the hot bed, the consumables on the hot bed are not cylindrical but have been crushed. On this basis, adjust 0.05mm each time until you try the most suitable height.
I hope this can help you.
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 06, 2019 2:55 pm
by ddanos
''Manual adjustment requires moving the nozzle to the middle of the print bed and zeroing the Z-axis'' I can't figure how to zeroing
Re: + 10 mm Z axis at beginning printing
Posted: Sat Jun 08, 2019 2:16 am
by ddanos
Please be more specific! Thanks.
Re: + 10 mm Z axis at beginning printing
Posted: Sun Jun 09, 2019 9:10 am
by William
Hi，you can use the manual controls in the slicing software to adjust the position of the z-axis.
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 13, 2019 2:14 am
by ddanos
I didn't succeed!
Please make step by step tutorial.
Thanks!
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 13, 2019 11:42 am
by William
Hi, you can do this to move the Z axis.
- 切片软件手动控制z轴移动.png (78.69 KiB) Viewed 13543 times
Re: + 10 mm Z axis at beginning printing
Posted: Thu Jun 13, 2019 4:37 pm
by ddanos
Well, I upgraded firmware to 1.1.8. Now on LCD main screen Z is blinking. The manual commands from any printing software not working anymore