Page 1 of 2
Driver Settings for A10M with easyprint3d
Posted: Mon Jul 22, 2019 11:48 pm
by go2xt@me.com
hey ,
sorry for my english it is verry bad sorry for this.
, i need the Printer File oder settings for the a10m. i use the geetech easyprint3d there is only the a10 in the pre settings
thx for the help
Re: Driver Settings for A10M with easyprint3d
Posted: Tue Jul 23, 2019 9:06 am
by William
Hi, I will send you the A10M configuration file for you.
Re: Driver Settings for A10M with easyprint3d
Posted: Wed Jul 24, 2019 9:17 am
by Chub
Is Easy print 3D a decent slicer? I also have an A10M. I am currently using Cura 4.0.
Re: Driver Settings for A10M with easyprint3d
Posted: Wed Jul 24, 2019 9:32 am
by William
Easy print also a slicer software, and you also can use Repetier-Host.
Re: Driver Settings for A10M with easyprint3d
Posted: Wed Jul 24, 2019 5:32 pm
by Chub
Can you send me the config file for the A10M for Easy print
Re: Driver Settings for A10M with easyprint3d
Posted: Wed Jul 24, 2019 5:36 pm
by William
Hi, Repetier Host is recommended, you can go to the official website to download.
Re: Driver Settings for A10M with easyprint3d
Posted: Thu Jul 25, 2019 11:28 pm
by go2xt@me.com
Hi, wre you sende the File?
I donload the Repetier Host file vom GT but i can`t import it in easyprint3d, the import files are only .ini
what is my mistake
Re: Driver Settings for A10M with easyprint3d
Posted: Fri Jul 26, 2019 9:31 am
by William
Hi, If you downloaded the Repetier Host configuration file via the following URL,
https://www.geeetech.com/download.html?download_id=31
You need the following:
First set the parameters of the printer,
Secondly, connect the printer;
Then disconnect and select the configuration on the right side of the slicing software;
- 配置.png (192.27 KiB) Viewed 10070 times
Select Print-import-select A10M PLA high .rcp to import and save;
- 配置0.png (158.36 KiB) Viewed 10070 times
In the material -import-select A10M PLA high fi.rcp to import and save, complete the configuration.
- 配置1.png (158.4 KiB) Viewed 10070 times
Re: Driver Settings for A10M with easyprint3d
Posted: Thu Oct 10, 2019 3:24 am
by xBiker
Hello, could You please also send me the config file for the A10m for Easyprint3D?
Re: Driver Settings for A10M with easyprint3d
Posted: Tue Dec 24, 2019 12:38 am
by Nicolas M.
I also need the configuration file. Could you send it please?