Page 1 of 2
Z Axis Endstop doesn‘t stop movement
Posted: Tue May 12, 2020 5:10 am
by nicoch
My Z axis endstop doesn‘t stop the z axis movement towards home anymore. If I home it I get a loud rattling noise. What are possible issues to look at and what codes are useful for debugging and posting the results here? Thanks!
Re: Z Axis Endstop doesn‘t stop movement
Posted: Tue May 12, 2020 11:44 am
by William
Hi,myfriend.
Can't z-axis stop?can you provide videos?
Re: Z Axis Endstop doesn‘t stop movement
Posted: Tue May 12, 2020 5:10 pm
by nicoch
Now it is different. The other axis seem to have problems too now.
https://streamable.com/mbipcr
The noise was the same for the Z axis, when using G28 command. When I used Simplyfy3D's JogMode to bring z to 0 there was no problems.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Wed May 13, 2020 10:40 am
by William
Sorry, I can't open this link. You can upload compressed video files.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Wed May 13, 2020 4:31 pm
by nicoch
here we go
Re: Z Axis Endstop doesn‘t stop movement
Posted: Thu May 14, 2020 11:53 am
by William
Hi,Is this 3D touch?
It may be that the wiring of the limit switch is not connected properly. You can check it.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Thu May 14, 2020 1:42 pm
by nicoch
yes, it is 3D Touch and wiring seems okay.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Fri May 15, 2020 1:43 pm
by William
Hi,according to the video you provided, the sound sounds like a limit switch failure.
You can check whether a lower limit switch lights up. If it doesn't, you need to replace it.
or you can provide a picrure of Z-axis and y-axis.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Fri May 15, 2020 10:00 pm
by nicoch
It is lit. It is red all the time and when something triggers it it gets a brighter red.
Re: Z Axis Endstop doesn‘t stop movement
Posted: Mon May 18, 2020 9:57 am
by William
Hi，what is the model?please