Page 1 of 1

X axis not responding

Posted: Mon Aug 03, 2020 3:26 pm
by burleykia
I have a Geeetech I3 Pro W with the gt 2560 A+ board and when I recently put together my printer I noticed that my x-axis stepper motor has no response or power going to it. I attempted to flash the newest version of the firmware to the board using the tutorial included with no results. Pretty desperate now as I emailed Geeetech with no response for about 4 or so days. Any help would be appreciated, thanks. best auto clicker

Re: X axis not responding

Posted: Mon Aug 17, 2020 4:21 pm
by William
Hi!
You can try to swap the X-axis driver with the Y or Z-axis driver, and test it again. It may be a driver failure, you can replace the driver. :D