Page 1 of 1
How can we use PID Autotune on the A30T?
Posted: Mon Oct 11, 2021 5:50 am
by MOCCOR
Is there a guide about using PID autotune for the Geeetech printers anywhere?
Re: How can we use PID Autotune on the A30T?
Posted: Mon Oct 11, 2021 5:13 pm
by Admin
MOCCOR wrote: Mon Oct 11, 2021 5:50 am
Is there a guide about using PID autotune for the Geeetech printers anywhere?
Sorry! We don't have this guide.
Re: How can we use PID Autotune on the A30T?
Posted: Tue Oct 12, 2021 2:38 am
by MOCCOR
Admin wrote: Mon Oct 11, 2021 5:13 pm
MOCCOR wrote: Mon Oct 11, 2021 5:50 am
Is there a guide about using PID autotune for the Geeetech printers anywhere?
Sorry! We don't have this guide.
Is there a way to do PID autotune on the hotend and bed? I know flashing other firmware it is possible. But this printers firmware does pretty much everything i've seen others do on Marlin. Maybe there is just a slightly different command than Marlin's for the PID Autotune?
Re: How can we use PID Autotune on the A30T?
Posted: Sat Nov 06, 2021 3:34 pm
by Admin
Sorry, we wouldn't suggest others modify the printer, that will cause some responsibility issues.
But if you need the source code, please check the link:
https://github.com/Geeetech3D/Prusa_I3_3Dprinter
Re: How can we use PID Autotune on the A30T?
Posted: Sat Nov 06, 2021 3:37 pm
by Admin
If you need thermistor, maybe you can try to check on our website:
https://www.geeetech.com/accessories-ho ... 6_108.html