Geeetech

I tried swapping those cables, but the the cables are infact very different and I cannot really swap them. Extruder cable is just a short jump cable from the motor to the board just under it and the z-axis cable is a longer cable that goes inside the chassis. I could attach the z-axis cable to the ...

Yes, I found the post about fixing the non-working extruder and I checked the cables. The colors match exactly to your picture

Hi,

Here's a video of the issue. I tried switching the drivers but it had no apparent effect in anything. I even tried the extrude/retract on the Easyprint 3d software when I updated the firmware but it had the same extrude-only behaviour.

https://youtu.be/u6sNG2twk8E

Here's an image of the ...

I swapped those driver boards, but the result is still the same. I will only extrude using either of the buttons

I have not tried doing that but I will do so now. Will update with the results

I tried all the slicer settings I could think of and everytime my printer would print the movement lines too(where printer would normally retract) and instead it extruded those too. When I first got my printer and I used the UI to install the filament it worked but when I wanted to change the ...