Geeetech

Thank you, I have also bought some PLA so will take your advice and try thhat first.

Do you know where to find the Config file mentioned in the user manual.

Thanks

I have finaly finishing building my Rostock 301 3D Printer and am in the process of setting it to start my first print. following the Manual i have levelled the Hot bed and am now on the set up the slicer softeare.

It mentions loading a Rostock 301 PLA config .ini file.

Where do i find this also ...

Thanks very muckh William, I have upgraded the firmware as you suggested. it now goes over the 220 mark, now I can get on witht the rest of the calibration

Thanks again for your help

I have just finished building the rostock 301 3D printer and am now configuring it.

I have ABS Filament and am trying to test the extruder, but it will not go above 220 Degrees. I have set it to go to 245 but it will get up to 222 and then drop to 218 and back to 222 degrees.

Doe sany one have any ...