Geeetech

They do look like a lot better quality extruder but I really hate to put more money into something that is still under warranty and I also didn’t think that this could be the issue since I started having problems with both extruders at the same time, I figured if it was the extruder that I would at ...

What should the steps be for each axis on the A20M? I am just wanting to check mine to see if they have been changed.

I took the jumpers off and they all were getting contact and I put them all back on and I still get the same results.

Thank you, I will look into that tomorrow. I forgot to add that both extruders are giving me the same results. I’m assuming the same jumper would have to be not making contact on both extruders.

When I did the estep calibration, I did change esteps to get a full 100mm to extrude but they were at 1200 And it was Really over extruding then. I’ve tried playing with the esteps but the mid 400s seem to be the best but I cannot get a consistent print

I can not get this dialed in. I am getting good prints in the beginning layers and then it starts to under extrude "I assume" about 6-10mm into the print. I have just replaced a new hot end with new nozzle and still get the same results. I am printing PLA at 205, have the esteps set to 430 "which ...

Thanks, I will give that a try. I have tried both extruders and still the same results but I haven't tried to clear the hot end yet.

I feel this is under extrusion but I cant fix it. I am using pla and in the pic the dog on the left is the original that I printed when I got my printer and it was at 205 degrees. I have tried
1. cleaning my nozzle and even replaced it
2. making sure tube is not obstructed
3. feed gear is plenty ...