Hi all
I'm new to 3D printing and I recently got a Geeetech A10. It seems to be working very well aside from one thing.
I'm getting a lot of stringing, and the print sticks to the bed a little too well (tricky to remove after printing). I tried to lower the temperature of both the hot end and the ...
Search found 2 matches
- Sat Jul 17, 2021 5:55 pm
- Forum: Geeetech A10 Series
- Topic: Geeetech A10 ignoring temperature settings
- Replies: 1
- Views: 1886
- Thu Jul 08, 2021 10:31 am
- Forum: Geeetech A20
- Topic: Geeetech A20 + BlTouch = first layer height question
- Replies: 0
- Views: 2319
Geeetech A20 + BlTouch = first layer height question
Hey,
i got an A20 from Geeetech and upgraded a BLTouch to it.
I followed the instructions to setting up the right nozzle height.
I adjusted the Z-Offset until a piece of paper (round about 0.1mm thick) is slightly
scratching on the nozzle when Z = 0mm. Therefore my nozzle is 0.1mm away from the ...
i got an A20 from Geeetech and upgraded a BLTouch to it.
I followed the instructions to setting up the right nozzle height.
I adjusted the Z-Offset until a piece of paper (round about 0.1mm thick) is slightly
scratching on the nozzle when Z = 0mm. Therefore my nozzle is 0.1mm away from the ...