I can't control the temperature and go up to 270-280 degrees.
What could be the problem?
A10M Overheating problem
A10M Overheating problem
After the first print, I encountered this error.
I can't control the temperature and go up to 270-280 degrees.
What could be the problem?
I can't control the temperature and go up to 270-280 degrees.
What could be the problem?
Re: A10M Overheating problem
Hi, maybe you need to replace the thermistor on the motherboard and measure the resistance between the blue and green lines on the hotbed.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A10M Overheating problem
i have the same problem with my a10! it just goes up and overheats! did you figure out why?
Re: A10M Overheating problem
Try to use some contact spray.
At the first print I was problem with Z axis, where are bad contacts due oxydation
At the first print I was problem with Z axis, where are bad contacts due oxydation
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.