I just downloaded, compiled, and flashed the Marlin 2.0.X firmware. I followed the instructions on vert's thread and downloaded it from the Marlin 2.0 Bugfix Branch linked on the thread.
Vert's Thread - http://www.geeetech.com/forum/viewtopic ... 20&t=68228
Marlin 2.0 Bugfix Branch - https://github.com/MarlinFirmware/Marli ... gfix-2.0.x
Everything works great but I don't think the printer has BLTouch auto-leveling enabled. I used the example config included for the A10M and when I select auto-level in the printers menu the printer just goes through the manual bed leveling process. I am relatively new to Marlin and after looking through the config file, I can't seem to figure out how to enable it. Any help would be appreciated.
BLTouch, A10M, and Marlin 2.0.X (need help)
Re: BLTouch, A10M, and Marlin 2.0.X (need help)
You can attach your configuration.h file and we can help to check it.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: BLTouch, A10M, and Marlin 2.0.X (need help)
Hi Vert, or any one that can help
Could you please re-post the location of your Marlin 2.0 for the A10m with BL touch, as i ,have used all you links with no success, the Thingiverse, errors 404.
Thank you
Could you please re-post the location of your Marlin 2.0 for the A10m with BL touch, as i ,have used all you links with no success, the Thingiverse, errors 404.
Thank you