Sensor Module Film Pressure Probe

[miike]

Hello.
Please tell me
I want to try " Module Film Pressure Probe for V6 Nozzle." for Z-axis calibration
However, I do not know where to install the wires.
Does the connector connect to End-Stop Z?

https://www.dropbox.com/s/55cu5qog9wyro ... .09.35.jpg

[William]

Hi, nice idea, but I‘m afraid can't use it.
about the board source you can refer to this and download: https://www.geeetech.com/download.html?download_id=43
I hope this can help you.

[miike]

Thank you for the tip William.
I will try it for reference.