A10 Super Plate Min Temp ERR

[Grezmel]

Hi all,

Been printing successfully for a while now and suddenly receiving ERR: MINTEMP, PRINTER HALTED please reset. I’m not using any bed clips.

I’ve had a look and can see any soldier issues.

Any ideas,?

[William]

Hi, you can check if your thermistor is fully connected.
If you are fully connected,
you can try to measure the thermistor with a multimeter.

[Grezmel]

Thanks all, there was a break in the green wire. There is quite a bit of movement with the wires as the bed moves back and forth.