I start printing but the screen is put on with these symbols and I don't extrude. It stays moving over one or two millimeters.
I get weird symbols on the screen and it stops printing
I get weird symbols on the screen and it stops printing
hi i need help
I start printing but the screen is put on with these symbols and I don't extrude. It stays moving over one or two millimeters.
I start printing but the screen is put on with these symbols and I don't extrude. It stays moving over one or two millimeters.
- Attachments
-
- lcd geeetech .png (654.58 KiB) Viewed 12403 times
Re: I get weird symbols on the screen and it stops printing
Hi, you can reconnect the screen cable
Screen interference may occur due to signal interference.
Screen interference may occur due to signal interference.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: I get weird symbols on the screen and it stops printing
I have been utilizing my Pruse i3 MK3S, and it has worked perfectly for ~3 months. I use OctoPrint on a Pi3B(+? can't recollect), and I have it in a fenced in area in the shed (temperature in shed right now ~3-7°C, moistness is genuinely high, however surely bring down that outside the shed) with both the force flexibly and Raspberry Pi outside the walled in area.
192.168.100.1 192.168.1.1 jpg to pdf
192.168.100.1 192.168.1.1 jpg to pdf