A20T start code

[Ade O]

hi im having a bit of weirdness happening ive set up cura to extrude at 208 and disengage the two extruders setting it up as 100,0,0 all is fine it comes up to temp then as it starts it resets to 215 and extruders reset to 34,33,33 I mean come on I have been trying to wrack my head over this gone through the settings on the machine itself but ive got no where, help please

Ade

[Ade O]

ok so is it poss for me too remove the settings for extruder temp and mix extruder mix from the start code without causing too many problems and will it then keep the settings sent via cura

[Zaphod_Beee]

Hello,

it looks this should help: (I did not try it yet)
viewtopic.php?f=117&t=69683
I have te same Probem.

Good luck!