This appares if i upload the firmware in Geeetech download page:
- IMG_20200610_174713_1.jpg (259.3 KiB) Viewed 2609 times
A10m and Arduino
A10m and Arduino
Hi! My motherboard of A10M is broken (i broak it by error.My mistake). I replace it with Arduino mega and ramps. I Load the Marlin 1.1.8 into Arduino ad it is ok. But if i load the file HEX i founded in Geeetech dowload pages ,nothing happens. I uploaded with cura and seems all ok. But on displaty appares some strange caracters and Arduino going frosen. I must to upload Marlin again. Can you hep,me? Thank you very much!
This appares if i upload the firmware in Geeetech download page:
This appares if i upload the firmware in Geeetech download page:
Re: A10m and Arduino
Hello, the motherboard you are using cannot use our firmware.
You can use the modified Marlin firmware on RAMPS 1.4.
choose a name from boards.h that match your settings.
Can be downloaded on the marlin official website
You can use the modified Marlin firmware on RAMPS 1.4.
choose a name from boards.h that match your settings.
Can be downloaded on the marlin official website
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!