3d touch setting

[albinszten]

Hello,



I put the 3d touch on my geeetech a20.



I have updated the firmware and the 3d touch works.



I'm having trouble adjusting the offset.



Once set: auto home then control with the z + sheet of paper.

I redo my corners then an autonomous for flush control.



I start printing and the nozzle is either too high or too base and I cannot print.



I tried dozens of settings in vain





Can you give me a tip because I can't do it.



I missed a step is not possible

[William]

Hi, you can refer to this:viewtopic.php?f=27&t=18371
Hope to help you.

[cdricyates]

Hi, you can refer to this:viewtopic.php?f=27&t=18371
Hope to help you.

Thanks a lot! I'll try that out.

[rouncewell]

I'm new to this and I'm looking for a better 3D touch settings. Thanks for link referral

--
rouncewell