Import from A20M Simplify3D?

[murfyjohngail]

Hello everyone there,

I was constantly using Cura but found printing with Simplify the prints even simpler and with incredible quality and in Cura, there were a lot of issues with this double ejection.
So this is the reason why I am asking how lucky is that any of you have an alternative to bring this printer to Simplify. The best would be with 2 standard extruders and 3 virtual extruders. (25/75, 50/50, 75/25)

Could someone, if it wasn't too much trouble, could help me?

Much obliged