I just finished setting up my printer and printed 2 things. Both of these prints failed so I decided to shut everything down and try again later. When I set everything backup I can connect to the printer and thats about it. Once I connect I am unable to send any command to the printer other then home. Everything I try all it does is stay idle. This is really confusing me since I printed to things just the other day.
168/3dprintersonlinestore.com <---- The printer I bought and assembled.
RAMPs issues.
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: RAMPs issues.
Could you please tell me you printer type so that I could send you the corresponding firmware.
And please leave your email address.
And please leave your email address.