stop switches don't stop the travel

[szeiger]

on all 3 axis, x y and z, stop switches don't stop the travel. The carriage will hit the stop, vibrate as it tries to travel farther, finally give up, back ooff a little, and then hit it again and stop. So it acts as if the stop switch needs to be pressed twice to actually stop.

Please help as soon as possible.

Scott

[zhangxueyou]

Please change the relevant values in firmware file "configuration.h":
"
const bool X_MIN_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
const bool Y_MIN_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
const bool Z_MIN_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
const bool X_MAX_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
const bool Y_MAX_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
const bool Z_MAX_ENDSTOP_INVERTING = false; // set to true to invert the logic of the endstop.
"
Please reverse the value.

[szeiger]

How do I edit that file?

[zhangxueyou]

Do you have firmware files? If you don't have, please tell me your mainboard type, and your printer type. I will send you the firmware.
Select all the files(Ctrl+A) and drag them into Arduino IDE 1.0.1, jump to "configuration.h", and find the codes I sent you before. Reverse the values.
Click Verify(icon"√"), if display "Done compling", then click Upload (icon"→“).

[szeiger]

8mm acrylic I3B with the singuinolou board

Thank you

[szeiger]

no to having firmware files
I have the 8mm I3B with the singuilo board

[szeiger]

no, I do not have the firmware files
I have the 8mm I# I3B with the singuilolo board.

Thank you

[szeiger]

szeiger@sjservices.com

[szeiger]

I do not have the firmware files
I3B sangino board

Thank you

[szeiger]

no, I do not have the firmware file
I have 3 I3B sanguilo board

szeiger@sjservices.com