X Y Z axis for those new to 3d printing

[szeiger]

Found this site while looking for some answers: reprapsquad.wordpress.com
Worth checking out

[szeiger]

Most of the problems I have had were related to not having X and Y configured correctly. If you are having trouble with the stop switches and homing, make sure X, the carriage that moves left and right, and Y, the hotbed/glass are plugged into the correct spots on the Sang board, with the X being towards the front of the printer, and then Y, Z, and then extruder.

Hope this helps someone.

Scott

[zhangxueyou]

Thank you for sharing.